Rear Power Steering Valve-cont.

TM 10-3930-634-34

(2) Inspect the end cap and housing for cracks and

moval of the valve assembly. Length of the link includ-

damage.

ing the valve assembly should be approximately 2131/64

(3) Inspect internal parts for nicks, scratches,

inches, measured from center to center of the grease

burrs or damage. Replace any defective parts.

fittings. Measurement may vary a fraction plus or

d. Reassembly. Refer to figure 5-21 and reassemble

minus from one forklift truck to another. Refer to fig-

the rear power steering valve.

ure 5-21 and remove the rear power steering valve.

e. Installation. Remove caps from hydraulic lines

b. Disassembly. Refer to figure 5-21 and disassem-

and reinstall lines to the valve.

ble the rear power steering valve.

NOTE

c. Cleaning and Inspection.

No pressure setting is required at the valve.

(1) Clean the rear power steering valve assembly

Check pressure at the pump. Correct pressure

components thoroughly, using solvent P-D-680 or

is 2000 25 psi.

equal.