(e) Press oil seal (9) from bearing retainer (8). If
(b) Press output shaft (1) with gear (2) and ball
sleeve (10) requires replacement, press from bearing
earing (4) installed from bearing retainer (8). Remove
gear (2) from output shaft.
(3) Pump Shafts.
(c) Remove retaining ring (3) and press output
(a) Disassemble the pump shafts in numerical
shaft (1) from ball bearing (4).
sequence as shown in figure 4-23.
(d) Remove retaining ring (5) and press ball
(b) Remove washer (1) and pump shaft bearing
bearing (6) from bearing retainer (8). Remove packing
locating retaining ring (2) from pump shaft.