 |
|||
|
|
|||
|
Page Title:
Figure 3-136. Comparison of main bearing shells |
|
||
| ||||||||||
|
|
 TM 10-3930-634-34
(3) If the taper is out of round and does not exceed
the limits listed in table 1-1 hone the liner to remove
any step or ridge at the top of the ring travel and to re-
move the glaze caused by the rubbing action of the pis-
ton rings.
(4) After the liner has been honed, clean the liner
and the cylinder block thoroughly with cleaning solved
P-D-680 and dry with compressed air.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals