Accelerator Pedal and Linkage - TM-10-3930-632-120076

TM 10-3930-632-12

Figure 4-34. Governor Adjustment

c. Move governor arm to full idle position.

g. Depress accelerator pedal (fig. 4-84) to pedal

d. Adjust governor surge screw inward until it

stop. Adjust accelerator slip yoke mechanism so that

washer "A" moves away from slip yoke "B" 1/8-inch.

just moves governor arm. Lock in place with locknut.

e. Install governor-to-carburetor linkage rod in

Tighten all nuts.

h. Adjust engine idle speed to 600/660 RPM.

full throttle position and adjust to approximately 1/16-

inch gap between carburetor stop pin and throttle arm

4-50. Accelerator Pedal and Linkage

stop.

f. Install governor spring and adjust no load

a. Removal and Disassembly. Remove and

engine speed to 2600 RPM.

disassemble the accelerator pedal and linkage as shown

4-48