CHAPTER 2 OPERATING INSTRUCTIONS - TM-10-3930-632-120016

TM 10-3930-632-12

CHAPTER 2

OPERATING INSTRUCTIONS

Section I. OPERATING PROCEDURES

2-1.

General

(2) Check that direction control lever is in

This section contains instructions for operating the fork

(neutral) position.

lift truck under normal conditions. Detailed instructions

(3) If engine is cold, pull choke control

are given to fully acquaint the operator with specific

fully out.

procedures of each function which the fork lift truck is

(4) Press and hold accelerator pedal one-

capable of performing. Since different tasks present

third of way to floor.

varying problems, the operator may have to alter any

(5) Turn starter and ignition switch fully

given procedure to suit the individual situation.

NOTE

clockwise to START. Hold until engine starts, then

release.

If equipment fails to operate, refer to

(6)

Hold

accelerator

one-third

troubleshooting procedures in Chapter 3.

application, allowing engine to warm up at fast idle.

CAUTION

2-2.

Starting

a. Preparation for Starting.

Do not operate starter motor continuously for

more than 30 seconds. If engine fails to start

(1) Perform the before-operation services

within that time, allow starting motor to cool 2

(table 3-1).

minutes before attempting to start again.

(2)

Insure that the truck is properly

(7) Check engine oil pressure light and

lubricated as specified in the Lubrication Order LO 10-

ammeter. They must show normal readings.

3930-632-12.

NOTE

(8) As engine warms up, push in choke

just enough to maintain smooth operation until it is fully

Prior to attempting any operation of the truck,

in.

the operator should thoroughly familiarize

CAUTION

himself with all controls and instruments and

Long periods of idling are detrimental to the

their respective locations.

b. Starting. Refer to figure 2-1 and start the

engine and waste gasoline. Shut off the engine

when the truck is not being operated.

truck in the following manner:

(1) Pull up on parking brake lever to make

sure it is fully engaged.

2-1