 |
|||
|
|
|||
|
Page Title:
Valves must be installed in the same cylinders from which they were removed. |
|
||
| ||||||||||
|
|
 TM 10-3930-630-34
1
Exhaust valve
6 Valve spring
2
Intake valve
7 Valve guide
3
Valve lock
8 Valve seat insert
4
Spring retainer
9 Valve tappet
5
Exhaust valve rotor
10 Distributor drive shaft
TA067442
Figure 11-2A. Valve mechanism removal and installation.
(2) Check inside diameter of valve guides.
NOTE
(a) Inside diameter should be 0.3432 to
Valves must be installed in the same cylinders from
0.3422 inch (8.74 to 8.69 mm).
which they were removed.
(b) Maximum diameter wear limit is 0.3447
d.
Remove valves guides as follows:
inch (8.75 mm).
(1) Clean valve guides by removing lacquer and
(c) Replace guides that do not meet the
other deposits by running a wire brush soaked with
above tolerances as illustrated in figure 11-3.
cleaning solvent (Fed. Spec. PD680) through guide.
e. Remove valve seat insert as illustrated in figure
114.
11-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals