Section II. DRIVE SHAFT

TM 10-3930-630-34

TA067432

Figure 10-2. Pivot arm bearing installation.

Section II. DRIVE SHAFT

b. Inspect shaft and universal joint mounting for

10-5.

General

cracks, breaks or other damage. Replace if damage is

noted.

The drive shaft is a conventional type. Universal joints

c. Replace all damaged or worn parts.

at each end of the tube rotate with the shaft and connect

d. Refer to LO 10-3930-630-12 and pack bearings

to the parking brake drum and drive axle differential.

thoroughly with grease. Make certain grease fully

The drive shaft connects the transmission to the parking

covers all bearing surfaces.

brake and drive axle.

10-8.

Drive Shaft, Reassembly and Installation

10-6.

Drive Shaft, Removal and Disassembly

a. Reassembly. Reassemble the drive shaft in

a. Removal. Refer to TM 10-3930-630-12 and

reverse numerical sequence as illustrated in figure 10-3.

remove the drive shaft.

b. Disassembly. Disassemble the drive shaft in

b. Installation. Refer to TM 10-3930-630-12 and

numerical sequence as illustrated in figure 10-3.

install the drive shaft.

10-7. Drive Shaft, Cleaning, Inspection and Repair

a. Inspect all bearings and bearing surfaces for

evidence of extreme wear or damage.

10-3