REPAIR OF WHEELS AND TIRES
Section I. DRIVE WHEELS
7-2. Drive Wheel, Removal and Disassembly
Remove and disassemble the drive wheel in numerical
a. The wheels used on all cushion tire lift trucks are
sequence as illustrated in figure 7-1.
machined castings. A chamfer is provided on the
outside of the wheel and on the end of the inside
diameter of the tire metal insert to facilitate alignment.
7-3. Drive Wheel, Cleaning, Inspection and Repair
b. To prevent damage to the wheel the tire must be
installed with the chamfered side of the wheel up during
a. Replace wheel if damage is noted.
b. Clean bearing cups and cones and replace if
4 Cotter pin
7 Bearing cone
10 Grease shield
13 Bearing cup
16 Drive or bull gear
2 Lock washer
5 Jam nut
8 Bearing cup
11 Bearing cone
17 Straight pin
3 Hub cap
6 Flat washer
9 Drive wheel
12 Drive tire
15 Lock washer
18 Spring pin
Figure 7-1. Drive wheel, disassembly and reassembly.