Hood and Fenders

b. Installation. Install the front grille in the reverse

Note. Loosen adjusting bolts top and side.

order of removal.

(1) Remove the retaining pin (12) securing

4-69. Hood and Fenders

the yoke pin (11). Drive the yoke pin out of the clevis

a. Removal. Refer to figure 4-63.

(10).

(1) Remove the two wingnuts 134) and

(2) Remove the four capscrews (3 and 14)

washers 135) securing the hood (5) to the frame.

and nuts (5 and 15), and the lockwasher 14).

Remove the hood.

Warning: Use a hoist or winch of sufficient

(2) Remove the four capscrew., lockwashers

and spacers securing the right and left hand fenders.

capacity to lift the counterweight, which weights

Be sure to note the size, quantity and location of the

approximately 3,125 pounds.

spacers. Remove the fenders.

(3) Remove the towing shackle (1) securing

b. Installation. Install the hood and fenders in the

the counterweight (6) to the frame (13). Remove the

reverse order of removal.

counterweight.

4-70. Counterweight

Note. Loosen adjusting bolts top and side.

a. Removal. (fig. 4-64).

Towing shackle

Washer

10.

Clevis

Capscrew

11.

Yoke pin

lockwasher

12.

Retaining pin

Nut

13.

Frame

Counterweight

14.

Capscrew

Nut

15.

Nut

Lockwasher

Figure 4-64. Counterweight removal.

b. Installation. Install the counterweight in the

(1) Clean the seat cushion and the back

cushion by washing with warm, soapy water.

reverse order of removal.

(2) Clean the remaining parts with a cleaning

4-71. Seat

solvent: dry thoroughly.

a. Removal. Remove four flanged nuts securing

(3) Inspect the cushions for cracks, cuts,

the seat assembly to the seat deck. Remove the seat

assembly.

b. Cleaning and Inspection.

4-52