 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 1.
Nut
11.
Washer
2.
Washer
12.
Pin
3.
Gasket
13.
Lever
4.
Bolt
14.
Rod
5.
Washer
15.
Bolt
6.
Gasket cover
16.
Lockwasher
7.
Gasket
17.
Plate
8.
Bolt
18.
Gasket
9.
Plate
19.
Manifold
10.
Bolt
Figure 4-5. Manifold.
b. Inspection.
c. Installation.
(1) The manifold should be checked for racks
(1) Install
new
gasket
(3,
on
and warpage. If cracked, replace. To check , warpage,
manifold.
lay a straightedge across the manifold parts. If warped,
(2) Position the manifold on the studs and
refer the problem to direct Iipport maintenance for
install the washers and self-locking nuts (1 and 2).
machining or replace.
Tighten the nuts to a torque of 32 to 35 ft.-lbs.
(2) Remove excessive (carbon deposits with
(3) Install
the
carburetor
a scraper and wire brush.
(3) Manifold gaskets must be in good
condition to prevent entry of dirt and to maintain correct
fuel-air ratio of intake mixture.
4-13
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals