Section VI. REPAIR AND REASSEMBLY

TM 10-3930-623-34

SECTION VI

REPAIR AND REASSEMBLY

part. The general instructions are applicable to each

6-1. SCOPE OF SECTION.

assembly being repaired and/or reassembled unless

6-2. This section contains instructions for repairing and

otherwise specified in the text. Where repair instructions

reassembling major components and accessories of the

for a part or unit are not covered in this section, the part

truck. Installation instructions for engine accessories are

or unit is not subject to rework and defective parts must

included in the engine assembly instructions. Installation

be replaced with new ones.

Where related to

of major components will be found in Section VII. The

reassembly, checks for clearances, backlash and

need for repair or replacement of parts is determined by

lubrication are included in the text in this section. Refer

performing the inspections and checking the dimensions

to figure 6-1 to locate repair, reassembly or inspection

as specified in Section VII. If the serviceability of a worn

data.

or damaged part cannot be restored by the repair

procedures specified in the following test, install a new

ITEM

INSPECTION DATA

REPAIR OR REASSEMBLY

Carburetor

Fuel Pump

Water Pump

Starter Motor

7-24 to 27

6-47 to 49

Distributor

7-29 and 30

6-45 to 46

Gasoline Engine

7-37 to 45

6-14 to 45

Transmission

7-46

6-52 to 60

Drive Axle

7-47

6-60 to 65

Master Cylinder

7-48

6-93 to 95

Wheel Cylinder

7-49

6-96 to 98

Brake Pedal

7-50

Hand Brake

7-51

6-99 to 100

Steering Axle

7-52

Steering Gear

7-53

6-65 to 115

Hydraulic Pump

7-56 and 57

6-111 to 113

Hoist Cylinder

7-58 and 59

6- 102 to 104

Tilt Cylinder

7-58 and 59

6-107 to 109

Control Valve

7-60 and 91

6-109 to 111

Uprights, Carriage and

7-61 to 65

6-104 to 107

Fork Assembly

Figure 6-1. Table of Inspection and Repair Data

6-1