Figure 3-19. Exhaust elbow, installed view

b. Installation. Refer to figures 3-19 and 3-20 and

install the muffler and pipes as follows:

(1) Install grommets (fig. 3-20) in muffler brack-

et. Install muffler on frame and secure with two

screws and lock washers.

(2) Connect exhaust and tail pipes to muffler and

secure with clamps (fig. 3-20). Attach tail pipe to

frame above rear wheel and secure with clamp, screw

and lock washer.

(3) Install exhaust elbow (fig. 3-19), with gasket,

on manifold and secure to studs with four nuts and

lock washers.

(4) Connect exhaust pipe to elbow and secure

with clamp. Tighten all clamps securely. Position

gasket correctly to provide against leakage.

Figure 3-19. Exhaust elbow, installed view

Figure 3-20. Muffler and pipes, exploded view

3-22