Figure 3-24. Single speed transmission disassembly (sheet 1 of 2)

(d) Remove separator plate bolts (3)

(I) Remove regulator valve spring (201

and lockwashers (4), separate plate (27), and gasket

and spool (21 ), and dump valve, spring (13) and spool

(26), and valve body gasket (22). Discard gaskets.

(14).

(e) Remove selector valve ball (7),

(5) Forward gear and shaft.

(a) Remove bolts (15, fig. 3-24) and

spring (6), and bushing (8).

(f) Remove selector valve stop (5), and

lockwasher (16) holding bearing retainer (14) and gasket

slide selector spool (9) from valve body (24).

(13) to case and remove retainer with gasket Discard

(g) Remove and discard oil seal (10).

gasket.

(b) Remove bearing retaining ring (17),

(h) Remove inching valve plunger stop

depress retaining ring on bearing, and slide bearing (12)

(23) and slide plunger (18) and spring (17) from valve

from forward shaft (11).

body (24).

(i) Remove and discard oil seal /(19).

through

valve

control

(j) Remove inching valve spool stop

opening, remove forward gear retaining rings (1U).

(d) Using a rawhide hammer and

(25), spool (16), and spring (15) from inside spool.

(k) Slowly remove regulator and dump

holding forward gear (9) in place, tap forward shaft (11)

out through bearing retainer opening. Remove

valve retaining screws (11) and gaskets (12). Discard

gaskets.

Figure 3-24. Single speed transmission disassembly (sheet 1 of 2)

3-28