Fifteen-DayOrganizational Maintenance

TM 10-3930-252-20P

ment Missile Army) funds for initial issue

d. Unit of Issue: This column indicates the unit

only to be used as exchange assemblies at

used as a basis for issue, e.g., ea, pr, ft, yd, etc

DSU and GSU maintenance level. These

e. Quantity Incorporated in Unit Pack: This column

assemblies will not be stocked above DSU

indicates the actual quantity contained in the unit pack.

and GSU or returned to depot supply level.

f. Quantity Incorporated in Unit: This column

Note. Source code is not shown on common

indicates the quantity of the item used in the functional

hardware items known to be readily available in

group.

Army supply channels through local procurement.

g. Fifteen-Day

Organizational

Maintenance

(2) Maintenance Code, .indicates the lowest

Allowance, Column (4) of Section II and Column (7) of

category of maintenance authorized to install ,the listed

Section IV.

item. The maintenance level code is:

(1) The allowance columns are divided into four

subcolumns. Indicated in each subcolumn is the quantity of

Code

Explanation

items authorized for the number of equipments supported.

O Organizational maintenance

Items authorized for use as required but, not for initial

(3) Recoverability Code indicates whether

stockage are identified with an asterisk in the allowance

unserviceable items should be returned for recovery or

column.

salvage. Items not coded are expendable. Recoverability

(2) The

quantitative

allowances

for

codes are:

organizational level of maintenance represents one

initial prescribed load for a 15-day period for the number

Code

Explanation

of equipments supported.

Units and organizations

Applied to repair parts and assemblies which

authorized additional prescribed loads will multiply the

are economically repairable at DSU and GSU

number of prescribed loads. authorized by the quantity

activities and normally are furnished by supply

of repair parts reflected in the appropriate density

on an exchange basis.

column applicable to the number of items supported to

Applied to high dollar value recoverable repair

obtain the total quantity of repair parts authorized.

parts which are subject to special handling and

(3) Organizational

units

providing

are issued on an exchange basis., Such repair

maintenance for more than 100 of these equipments

parts normally are repaired or overhauled at

shall determine the total quantity of parts required by

depot maintenance activities.

Applied to repair parts specifically selected for

converting the equipment quantity to a decimal factor by

salvage by reclamation units because of

placing a decimal point before the next to last digit of

precious metal content, critical materials, high

the number to indicate hundredths, and multiplying the

dollar reusable casings or castings (4) This

decimal factor by the parts quantity authorized in the 51-

column also lists, below the SMR code, an

100 allowance column. Example, authorized allowance

index number for each item in ascending

for 51-100 equipments is 40; for 150, equipments

numerical sequence, which is used to locate

multiply 40 by 1.50 or 60 parts required.

items in the publication when the Federal stock

(4) Subsequent changes to allowances will be

number and/or reference number is known.

limited as follows: No change in the range of items is

b. Federal Stock Number: This column indicates

authorized.

If additional items are considered

the Federal stock number for the item.

necessary, recommendation should be forwarded to U.

c. Description: This column indicates the Federal

S. Army Mobility Equipment Command for exception or

item name and any additional description of the item

revision to the allowance list. Revisions to the range of

required. A part number or other reference number is

items authorized will be made by this Command based

followed by the applicable five-digit Federal supply code

upon engineering experience, demand data, or TAERS

for manufacturers in parentheses. Material required for

information.

manufacture or .fabrication is identified.