Transmission disconnect control

TM 10-3930-242-34

192

Bearing

186 Bearing

193

Bushing

187 Gear

194

Shaft

188 Ring

195

Gear

189 Spacer

196

Spacer

190 Gear

197

Bearing

191 Bearing

Figure 4-2. Torque converter and transmission assembly,

disassembly and reassembly (sheet 12 of 13).

(3) T r a n s m i s s i o n

connected without moving the valve or the con-

disconnect

control

linkage. T h e t r a n s m i s s i o n d i s c o n n e c t c o n t r o l

trol. Then try the control in each range position.

v a l v e is linked to a manual control valve, ex-

M a k e minor adjustments, if necessary, to insure

p r e s s l y for inching. This valve is the transmis-

that the elector valve detent seats at every

s i o n disconnect control valve. The transmission

r a n g e position of the operator's control.

d i s c o n n e c t control valve is located under the

(2) Forward-reverse linkage. T h e f o r w a r d

d r i v e r ' s floor board. For removal and installa-

and reverse control linkage must be adjusted so

t i o n , refer to figure 45. The linkage must be

t h a t the neutral, forward, and reverse detent

a d j u s t e d to insure full application and full re-

p o s i t i o n s of the valve correspond exactly with

l e a s e . The disconnect control valve has a total

t h o s e of the operator's control. This adjustment

linear movement of 3/8 inch from full retract (re-

i s made in a manner similar to the adjustment

leased) to full extension (applied).

of the range selector linkage ((1) above).