Figure 4-2. Torque converter and transmission assembly, disassembly and reassembly (sheet 6 of 13).

TM 10-3930-242-34

Figure 4-2. Torque converter and transmission assembly,

disassembly and reassembly (sheet 6 of 13).

(h) Position the transfer housing upright,

(j) R e m o v e t h e r e m a i n i n g p l u g s i n t h e

housing as necessary for cleaning or repair. Do

and using a soft drift, drive the rear output

not remove the rear output, disconnect shaft oil

shaft (194), bearing (197), and spacer (196) far

enough toward the rear to free it from the out-

s e a l unless replacement is necessary.

d. Cleaning and Inspection.

p u t transfer driven gear (195) and the bearing

a n d spacer.

(1) Clean all parts with solvent such as

(i) P o s i t i o n t h e t r a n s f e r h o u s i n g , f r o n t

P - D - 6 8 0 , or equal. Dry thoroughly.

(2) Inspect all parts for nicks, dents, burrs,

d o w n w a r d , and remove the transfer driven gear

(195). Remove the bearing remaining in the

s c r a t c h e s , evidence of overheating, or other de-

transfer housing,

f e c t s . Discard gaskets and replace with new