Figure 3-47. Flywheel housing bolt, tightening sequence (operation 2).

TM 10-3930-242-34

Figure 3-47. Flywheel housing bolt, tightening sequence

(operation 2).

f r o m overhaul stand and install all accessories

(14) Install the flywheel (para 3-21).

t h a t were previously removed.

(15) Install the limiting speed governor

(18) Install the engine (para 2-5).

(16) Install the oil pump inlet pipe and

( 1 9 ) Refer to the current lubrication order,

s c r e e n assembly (para 3-25).

and refill crankcase to FULL mark on dipstick.

( 1 7 ) Affix a new gasket to the oil pan, and

install oil pan (para 3-24). If engine was

( 2 0 ) Refill cooling system, if drained (TM

m o u n t e d on an overhaul stand, remove engine

10-3930-242-12).