Figure 2-8. Depositing load. - TM-10-3930-242-120026

TM 10-3930-242-12

STEP 1:

CAREFULLY DRIVE UP TO POSITIO WHERE LOAD IS TO BE DEPOSITED.

STEP 2:

DEPRESS INCHING PEDAL.

PUSH FORK EXTENSION CONTROL LEVER FORWARD TO EXTEND FORKS

STEP 3:

LONGITUDINALLY.

PUSH FORK TILT CONTROL LEVER FORWARD TO TILT CARRIAGE TO VERTICAL POSITION.

STEP 4:

STEP 5:

IF LOAD IS TO BE DEPOSITED ON GROUND LEVEL, PUSH FORK LIFT CONTROL LEVER

FORWARD AND ALLOW LOAD TO LOWER SLOWLY TO RESTING PLACE. CONTINUE TO

LOWER FORKS UNTIL THEY CAN BE EASILY WITHDRAWN FROM PALLET. THEN PROCEED

WITH STEP 10.

STEP 6:

IF LOAD IS TO BE DEPOSITED ON A TIERED STACK, PULL FORK LIFT CONTROL LEVER

BACK UNTIL LOAD REACHES DESIRED HEIGHT ABOVE TIER, THEN PROCEED WITH STEPS

7 THROUGH 10.

STEP 7:

RELEASE INCHING PEDAL ABOUT HALFWAY AND INCH TRUCK FORWARD UNTIL LOAD IS

ABOVE ITS RESTING PLACE.

STEP 8:

DEPRESS 'INCHING PEDAL.

STEP 9:

PUSH FORK LIFT CONTROL LEVER FORWARD AND LOWER LOAD CAREFULLY TO ITS

RESTING PLACE. CONTINUE TO LOWER FORKS UNTIL THEY CAN BE EASILY WITHDRAWN

FROM PALLET.

STEP 10:

PLACE FWD-NEUT-REV CONTROL LEVER IN REV AND RELEASE INCHING PEDAL.

TA072391

Figure 2-8. Depositing load.

2-10