WARNING - LO-10-3930-669-120002

LUBRICATION ORDER

10-3930-669-12

Drycleaning solvent (P-D-680) is TOXIC and flammable. Wear protective goggles

and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and

clothes; and do not breathe vapors. Keep away from heat or flame. Never smoke

when using solvent; the flashpoint for type I drycleaning solvent is 100F (38-C)

and for type II is 138'F (5OC). Failure to do so may result in injury or death to

personnel.

If personnel become dizzy while using cleaning solvent, immediately get fresh air

and medical help. If solvent contacts skin or clothes, flush with cold water. If

solvent contacts eyes, immediately flush eyes with water and get immediate

medical attention.

Cleaning. Clean grease fitting and grease gun

for Active Army Units. Reserve and National

tip before lubricating. Clean parts with

Guard activities will use 50 hours or 180 days,

drycleaning solvent (P-D-680, Type II or

whichever occurs first, as prescribed interval.

equivalent). Dry before lubricating. After

Hydraulic fluid will be sampled once a year.

high-pressure washing, lubricate all fittings and

Sampling will be performed as prescribed by

oil can points outside and underneath the

DA Pam 738-750.

forklift. Drain if water is found. For corrosion

control, refer to TM 10-3930-669-10.

Warranty Statement. For Equipment under

manufacturer's warranty, hard-time oil service

AOAP Sampling. Engine oil must be sampled

intervals shall be followed. Intervals shall be

at 50 hours of operation or 90 days, whichever

shortened if lubricants are to be contaminated or

occurs first, for Active Army Units.

if operation is under adverse conditions such as

Transmission oil must be sampled at 100 hours

longer than usual operating hours, extended

of operation or 90 days, whichever occurs first,

idling periods, or extreme dust.

Card 2 of 22