Click here to make tpub.com your Home Page

Page Title: S/N 2000 AND BELOW
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

LO 10-3930-643-12
LUBRICATION ORDER
filler cap and breather assembly
S/N 2000 AND BELOW
into reservoir (22). Install front
left access cover.
Each brake has Its own pressure
converter.  The pressure converter
If fluid level is low, check for and
hydraulic cylinders are supplied by
leaks at pressure con-
correct
one remotely mounted brake fluid
verters, fluid reservoirs, hydraulic
reservoir. The reservoir is located
lines,  and brake calipers. Fluid
on the inside front frame on the
level may also be low due to air in
left side of the forklift.
the hydraulic lines. If so, bleed
described  in  TM
the  lines  as
Remove front left access cover.
10-3930-643-20.
Remove filler cap (21) and breather
assembly from reservoir (22). Remove
and discard gasket (23). Visually
check the fluid level. If the fluid
is below one and one-half inches
from the top, fill the reservoir as
necessary,  using the proper brake
fluid.
TOXIC/FLAMMABLE
Dry cleaning solvent (P-D-680),
used for cleaning parts, is
toxic and flammable. Use only
in well ventilated areas. Wear
protective goggles and gloves.
Do not smoke or allow open
flames or sparks in areas where
cleaning solvent is used or
Avoid contact
with
stored.
LUBRICANT HAZARD
eyes,  skin or  clothing. If
contact with eyes  is made,
Brake fluid, lubricants, and
flush with cold water and seek
other  chemicals
can  cause
medical attention immediately.
SERIOUS INJURY to eyes. If
If  contact  with  skin  or
your eyes are affected, flush
clothing is made, flush with
immediately with cold water
cold water. If you become dizzy
and seek medical attention.
while using cleaning solvent,
get fresh air immediately.
Brake fluids DOT 3 Type SAE J
1703 and DOT 4 Type SAE J
1702 are flammable.
Unscrew the breather plug (24) from
the breather assembly. Clean with
P-D-680.
Do not mix brake fluids. Refer
to LUBRICATION SPECIFICATIONS.
Screw
breather
plug  (24)  into
Mixing fluids will damage the
breather assembly. Replace gasket
system.
(23) on filler cap (21). Install
Card 11 of 17

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business