Quantcast ENGINE OIL LEVEL HOT OR COLD CHECK

 

Click here to make tpub.com your Home Page

Page Title: ENGINE OIL LEVEL HOT OR COLD CHECK
Back | Up

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
EXPECTED TEMPERATURE - LO-10-3930-632-120004
Up
LO-10-3930-632-12 Truck Lift Fork; Gasoline Engine Driven Solid Rubber Tired 127-Inch Lift; 2 000 lb Capacity Manual
LO 10-3930-632-12
NOTES - CONTINUED:
3. ENGINE OIL LEVEL HOT OR COLD CHECK. Cold
remove filter element, clean housing, In- stall new
engine, oil level should be at high mark on dipstick.
element and refill with OE/HDO.
Hot engine, oil level must be between high and low
Operate hydraulic system for 5 minutes, check for leaks,
marks on dipstick (allow to set 5 minutes before
check level and bring to "FULL" mark.
checking).
10. WHEEL BEARINGS. Each 1000 hours, remove
4. ENGINE. Oil is to be changed each 250 hours.
wheels, clean and inspect all parts, replace damaged
Drain when lubricant is warm.
or worn parts, repack bearings, and assemble.
5. ENGINE OIL FILTER. Each 250 hours, remove filter
11. LUBRICANTS. The following is a list of lubricants
cartridge, clean housing and install new filter cartridge.
with military symbols and applicable specification
After installing new filter cartridge, fill crankcase, operate
numbers.
engine for 5 minutes, check hous- ing for leaks, check
crankcase oil level and bring to "FULL" mark.
E/HDO
MIL-L-2104
6. CRANKCASE BREATHER AND CRANKCASE FILL
GAA
MIL-G-10924
CAP. Each 50 hours remove cap, and clean
OEA
MIL-L-46167
breather.
BFS
MIL-B-46176
(SD), Type II
P-D-680
7. TRANSMISSION CONVERTER AND
ATF
Type A Suffix A
DIFFERENTIAL. Check level each 10 hours with
engine running at idle speed, oil at operating
temperature and transmission in neutral. Maintain oil
at "FULL" mark. Change oil each 1000 hours. Fill
transmission to "LOW" mark and run engine at idle
Copy of this Lubrication Order will remain with the
speed to fill con- verter and lines. With engine
equipment at all times, instruc- tions contained herein
running at idle speed, oil at operating temperature
are mandatory.
and transmission in neutral, add oil to br- ing to
"FULL" mark. Operate for 5 minutes and check for
By order of the Secretary of the Army:
leaks.
JOHN A. WICKHAM, JR.
8. TRANSMISSION EXTERNAL OIL FILTER. Each
General, United States Army
1000 hours, remove filter cartridge, clean housing
Chief of Staff
and install new filter cartridge. With engine running
OFFICIAL:
at idle speed, oil at operating temperature and
transmission in neutral, add oil to bring to "FULL"
ROBERT M. JOYCE
mark. Operate for 5 minutes and check for leaks.
Major General, United States Army
The Adjutant General
9. HYDRAULIC RESERVOIR. Each 500 hours check
level and bring to "FULL" mark. Each 1000 hours, drain
DISTRIBUTION:
reservoir,
To be distributed in accordance with DA Form 12-25A,
Operator and Organizational maintenance requirements
for Forklift Trucks
TA 219944
LO 10-3930-632-12
* U GOVERNMENT PRINTING OFFICE: 1984-420-
903/216CARD 5 OF 5

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc.