25 JAN 84
(Supersedes LO 10-3930-630-12, 13 SEPTEMBER 1976)
TRUCK, LIFT, FORK, GASOLINE, SOLID RUBBER
TIRED WHEELS, 4000 LB CAPACITY, 100 AND 180
INCH LIFT, ARMY MODEL MHE-231, ALLIS CHALMERS
MODELS ACC 40-24PS 100 AND ACC 40-24PS 180
(NSN 3930-00-590-7814) (100 IN.)
(NSN 3930-00-556-4955) (180 IN.)
Reference: TM 10-3930-630-12 and FEDERAL SUPPLY CATALOG C9100-1L.
Hard time intervals and the related manhour times are
Clean parts or fittings with dry cleaning solvent (SD),
based on normal operation.
The man-hour time
Type II or equivalent. Dry before lubricating. Dotted
specified is the time you need to do all the services
arrow shafts indicate lubrication on both sides of
prescribed for a particular interval. Change the hard
equipment. A dotted circle indicates a drain below.
time interval if your lubricants are contaminated or if you
Relubricate all it-ms found contaminated after fording or
are operating the equipment under adverse operating
conditions, including longerthan-usual operating hours.
The hard time interval may be extended during periods
The lowest level of maintenance authorized to lubricate a
of low activity. If extended, adequate preservation
point is indicated by one of the following symbols as
precautions must be taken.
appropriate: Operator/Crew (C); and Organizational
Dry cleaning fluid is flammable. Do
Reporting errors and recommending improvements.
You can help us improve this manual. If you find any
not use near a flame or excessive
mistakes, or if you know of a way to improve the
Use only with adequate
procedures, please let us know. Mail your letter or DA
Form 2028 (Recommended Changes to Publications and
breathing of vapors and minimize
Blank Forms) direct to: Commander, US Army Tank-
Automotive Command, ATTN: DRSTA-MB, Warren, Ml
48090. A reply will be furnished to you.
*The time specified is the time required to perform all services at the particular interval.
LO 10-3930-630-12 CARD 1 OF 6
LUBRICANT · INTERVAL
INTERVAL · LUBRICANT