NOTES - CONTINUED:
prescribed in the Key, OEA lubricant is to
be used in place of OE/HDO-10 lubricant
for all temperature ranges where
OE/HDO-10 is specified in the Key.
2. OIL CAN POINTS. Each 250 hours,
lubricate seat brake linkage, accelerator
pivot points, and all adjusting threads
3. STEER WHEEL BEARINGS.
1000 hours, remove wheels, clean and
inspect all parts, replace damaged or
worn parts, repack bearings, and
Each 250 hours,
check level. Change gear lubricant only
when required by maintenance repair
action, contamination by water, or other
foreign material. After refill, operate for
five minutes, check for leaks and bring oil
level to level plug opening.
5. HYDRAULIC SYSTEM. Each 50 hours
check oil level. Each 1000 hours drain
reservoir, remove filter element, clean
filter shell and install new filter element.
Clean sump strainer and reinstall drain
Copy of this Lubrication Order will remain
plug. Fill reservoir, operate lift for 5
with the equipment at all times,
minutes, check for leaks, check oil level
instructions contained herein are
and bring to "FULL" mark.
6. LUBRICANTS. The following is a list
By order of the Secretary of the Army:
of lubricants with military symbols and
applicable specification numbers.
JOHN A. WICKHAM, JR.
General, United States Army
Chief of Staff
ROBERT M. JOYCE
Major General, United States Army
The Adjutant General
( S D ) , Type II
To be distributed in accordance with
DA Form 12.25A, Operator and Organi-
zational maintenance requirements for
* U.S. GOVERNMENT PRINTING OFFICE: 1994-420-903/281