(Supersedes LO 10-3930-625-12, 4 FEBRUARY 1972)
28 AUGUST 1984
TRUCK, LIFT, FORK, ELECTRIC, SOLID RUBBER
TIRES, 4,000 LB CAPACITY, 100-INCH LIFT
(DREXEL DYNAMICS MODEL FL-40-EE-6550, ARMY
MODEL MHE 218) (NSN 3930-00-403-5661) AND
180-INCH LIFT (MODEL FL-40-EE-6250)
Reference: TM 10-3930-625-12, and FEDERAL SUPPLY CATALOG C9100-IL.
Hard time intervals and the related man-
Clean parts or fittings with dry cleaning
solvent (SD), Type II or equivalent. Dry
hour times are based on normal
before lubricating. Dotted arrow shafts
operation. The man-hour time specified is
the time you need to do all the services
indicate lubrication on both sides of
equipment. A dotted circle indicates a
prescribed for a particular interval.
drain below. Relubricate all items found
Change the hard time interval if your
lubricants are contaminated or if you are
contaminated after fording or washing.
operating the equipment under adverse
The lowest level of maintenance
operating conditions, including longer-
authorized to lubricate a point is
than-usual operating hours. The hard time
indicated by one of the following symbols
interval may be extended during periods
as appropriate: Operator/Crew (C); and
of low activity. If extended, adequate
Organizational Maintenance (0).
preservation precautions must be taken.
Reporting errors and recommending
improvements. You can help improve this
manual. If you find any mistakes, or if you
know of a way to improve the procedures,
Dry cleaning fluid is flammable. Do
please let us know. Mail your letter or DA
not use near a flame or excessive
Form 2028 (Recommended Changes to
heat. Use only with adequate ven-
Publications and Blank Forms) direct to:
tilation. Avoid prolonged breathing
Commander, US Army Tank-Automotive
of vapors and minimize skin
Command, ATTN: DRSTA-MB, Warren, Ml
48090. A reply will be furnished to you.
*The time specified is the time required to perform all services
at the particular interval.
CARD 1 OF 5